ClubRoadster.net banner

Monsterflow help

1K views 10 replies 9 participants last post by  Doppelganger 
#1 ·
I recently got a Monsterflow (R-speed) intake, new but no instructions. There is a couple issues I need help with.

1. There is no connection on the monsterflow for the air bypass hose, so for now I corked it. Car idles too low when cold, I suspect it's this.

2. There are 2 holes in the middle of the rigid tube, 1 had a fitting for vacuum hose to VC, the other was just a hole with rubber grommet, so I plugged it for now with a screw (threads wrapped in tape to seal it).

3. The bracket to attache filter housing to engine is no where near long enough, where is it supposed to attach to ?
 

Attachments

See less See more
3
#2 ·
I have the carbon Monsterflow, so there are some design differences. For example, there is a connector for the bypass hose in #1.
Didn't really see a question for #2, though I guess "what's the 2nd hole for?" is implied. No idea here.
#3, in my case, the bracket attaches to the bolt for the front engine hoist hook.
 
#5 ·
That's what I was starting to think, can any of you NB guys confirm that ?

I'll try to mount to PS else I'll have to make a new bracket.
Maybe I can plumb the air valve to the other hole, quite a bit smaller though.
 
#8 ·
lol, they sent u an NB one for sure... XD lmao, u plugged the IAC hose..............
 
#9 ·
Bought it off this forum, was advertised for 94-97.

Had no choice but to plug that hose for now, will plumb it over to the other hole for now. :dunno:
The bracket won't reach the PS or anything else, easy enough to fab a new one.

If I come across another for a 97 (anyone ?), I'll sell this one
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top