ClubRoadster.net banner

Weapon-R Dragon ram Air intake for NA8C.

5K views 13 replies 9 participants last post by  dustin a 
#1 ·
#4 ·
lmao, n00b's helping n00b's...


just make a DIY intake homie, I spent about $20 total on mine. Possibly lost MAYBE 1tq in the low end but gained GREAT throttle response, badass intake sound, and much nicer top end..





Not sure how much work is involved doing something similar to an NA, but I can imagine you can come up with something similar or figure out how to make your own, it's very easy..
 
#5 ·
oh snap! guess imma try do a homemade one since im a bit "Broke." btw Where'd you get the intake tube and filter from?
 
#11 ·
It was cut from the oem intake. Then just drilled a spot for the sensor and drilled a spot for a grommet and fitting to run the hose from your valve cover. (I don't recommend just putting a filter on the valve cover, there's a reason it's not atmospherically vented but that's a whole different subject.)


How do you get the maf wires all the way over there?
Just undo part of the harness til it can reach? Or extend the wires..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top