ClubRoadster.net banner

Ride Height Uneven? (Need help adjusting coilovers)

15K views 8 replies 8 participants last post by  Static Nine Garage 
#1 · (Edited)
I noticed that the wheel gap on the driver's side was about half an inch higher than my passengers side.. So I attempted to lower the driver's side. I lowered the driver's side rear so that the wheel gap was about the same as the passenger's side rear. However, the measurements are off as shown in the pictures.

I don't understand why the measurements are different but the wheel gap is now even? Am I adjusting it wrong? I'm confused.

I also measured the springs on both the driver side rear and the passenger side rear, and the springs are both approx. 6.5 inches.

There's almost an inch of a difference.. :suicide:

Driver side rear:




Passenger side rear:




Also, I measured the full coilovers and one is a little more than 11 inches and the other is almost 12 inches.. O_O

First time ever dealing with coilovers so any help is appreciated. This is the method I used to adjust the ride height:
 
See less See more
1 2
#5 ·
if you ever get to see a properly corner weighted car that's set up for racing, you may notice that the wheel gap is uneven all the way around. Weight distribution causes this and it's completely normal
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top